Safecoat Asphalt Driveway Sealer is a low odor elastomeric sealer and topcoating for asphalt surfaces. It helps to reduce the offgassing and offensive smells generated by new asphalt, while preserving and renewing existing asphalt surfaces.
USE ON: Safecoat Asphalt Driveway Sealer can be used on unsealed or previously sealed asphalt surfaces. It can also be mixed with sand to make an asphalt driveway patch for small areas.
SURFACE PREPARATION: All surfaces must be clean, dry, free from dirt, dust, grease, loose sand or any other foreign matter. Use a high pressure water wash with a solution of SafeChoice Super Clean and warm water to clean surface; additional scrubbing may be necessary. Rinse thoroughly with clean water and let dry. Safecoat Asphalt Driveway Sealer can be applied over damp, but not wet, surfaces. Mix Safecoat Asphalt Driveway Sealer with equal parts of sand to make a patch for small damaged areas in asphalt. Allow patch to dry 12-24 hours before topcoating.
COVERAGE: One gallon of Safecoat Asphalt Driveway Sealer covers approximately 100-600 square feet per gallon depending on dilution and surface condition (porosity). Coating that has been mixed 1:1 with sand will normally coat about 15-50 square feet per gallon.
CLEAN-UP: Clean tools and equipment with a diluted solution of SafeChoice Super Clean and warm water.
DRYING/CURING TIME: Under normal conditions, Safecoat Asphalt Driveway Sealer dries within 2-4 hours. Material appears brown/gray during application and is black when dry. If coating remains tacky after 24 hours, mix 1 part sand, 1 part water, 1 part Safecoat Asphalt Driveway Sealer and coat surface again. Coating should dry without any serious tackiness.
View Asphalt Driveway Sealer data sheet.
View Asphalt Driveway Sealer MSDS.
Product color: black
Updating...














