Safecoat 3 in 1 Adhesive is a low odor, not toxic, water-based adhesive designed for hard composition wall and floor tiles and carpeting.
Safecoat 3 in 1 Adhesive is a multi-purpose low odor, not toxic, formaldehyde free, water-based mastic adhesive designed for adhering floor tiles made of ceramic, vinyl, parquet, and slate; for lightweight wall tiles; and for any carpet application where a typical carpet adhesive would be used.
USE ON: Safecoat 3 in 1 Adhesive is recommended for adhering floor tiles made of ceramic, vinyl, parquet, formica and slate; for lightweight wall tiles; and for any carpet application where a typical carpet adhesive would be used.
ADVANTAGES / SIGNIFICANT BENEFITS:
- Low odor, non-offensive to installer and occupant.
- Safely used by and for the chemically sensitive.
- Very low VOC content, meets or exceeds all federal and state air quality regulations, including California.
- Contains no formaldehyde.
View 3 in 1 Adhesive data sheet.
COVERAGE: 50-60 square feet per gallon with 1/8” notched trowel. 100-120 square feet per gallon with 1/16” notched trowel.
CLEAN-UP: Clean tools and equipment while they are still wet with a solution of SafeChoice Super Clean and warm water.
DRYING/CURING TIME: 24 hours for full cure.
LIMITATIONS: Do not apply to substrate in direct sun or where hot to the touch as this will cause excessively fast curing and prevent adhesion into a wet, tacky base. Sample test a small area to assure proper adhesion can be obtained. Use only where room and surface temperatures are above 55 degrees and below 90 degrees F. Do not freeze. Unused contents should be kept in a closed container in a cool, dry place out of direct sunlight. Unlike conventional adhesives, Safecoat adhesives are made without formaldehyde preservatives or toxic mildewcides or fungicides. Do not contaminate.
Updating...
